Installation Guide for Cabevibe Upgrade Mesh A518

Installation video tutorial

Welcome to the Cabevibe ergonomic chair installation tutorial! Today, we will walk you through the installation process of this chair. The installation process is simple and intuitive. Just follow our steps step by step and you will be able to complete it easily!

(Note: Make sure to align the part of all screws with the holes and hand-tighten them first before using the Allen wrench to fully secure them. This helps prevent any misalignment that could make it difficult to properly assemble.)

Check if all parts are complete

Let's check all the parts. You will see: Headrest, Seat, Backrest, Armrest x 2, Center Base, Decorative Cover, Gas Lift, Block, Screw Pack, User Guide, Caster x 5, Leg Tube x 5. Make sure every part is in the package for a smooth installation.

Install the Center Base and Casters

First, install the Leg Tubes and Casters on the Base. Align and M6*15 screw each Leg Tube, align each Caster with the interface on the Base, and press firmly until you hear a click to ensure that the Caster is fully fixed, then place the Decorative Cover on the Base.

Install Gas Lift

Next, install the Gas Lift. Insert the Gas Lift into the hole in the center of the Base. The Gas Lift will help you adjust the height of the Seat.

Install Backrest and Seat

The most labor-saving solution is to place the Seat on top of the box. Align the Backrest with the attachment holes on the Seat. Use 4 x M8*30 Screws to connect the Seat and Backrest. Tighten them by hand first to make sure they are in the correct position before tightening them with an Allen Wrench.

Installing Armrests

Corresponding to the left and right logos of Armrests. Align the Armrests with the mounting holes on the Seat, insert the 6 x M6*30 Screws and tighten.

Insert the Seat into the Base

Align the Gas Lift with the Seat connection position.

Installing the Headrest

Place the Block on the edge of the Backrest and slowly slide it to the middle to find the right fit. Then place the headrest on the measuring line in the middle of the backrest, combine it with the block, and tighten it with M6*25 screws.

Congratulations, your Cabevibe ergonomic chair has been successfully installed! Now you can adjust the chair height, the angle of the backrest and the position of the armrests to find the most comfortable sitting position.